Any advice on upgrading RD 350 suspension and rims? It's gonna remain a streetbike but if I can swap out the forks and rims I'd be interested....
I've been away from the track for long time and my former resources seem to have evaporated. I am looking to get some suspension work done on a...
Hey gang just a note. Check your OnStar account if you have one. Turns out I've been paying double on my account being charged for a vehicle I...
I'm looking around for reasons not to separate the cases on the SV. What would cause this bluing of the area around the timing chain gear on the...
I tried to PM you but couldn't. Need some help.
I sent my heads off to a forum member for a rebuild, the cylinders are just a tad above the wear limits for stock pistons, and I am wondering...
Is there anyone in particular from the forum or a resource that cuts down seats? I'm a short guy and I'd like to get my seat cut down on the SV...
I am getting these broken English messages from people that say they want to buy my bike. They are in the mountains and can't call, but they can...
Not to start a debate or a 10 mile thread of opinions but I have a question for those that build engines. Here goes My SV book says that my...
I hate these barriers and avoid being around them like the plague. RIP...
I tell ya, I'm paying the price for letting my bikes sit. Now the R6 won't run but I deserve it. I'm pretty good with carbs but not fuel...
I was told, years ago "not" to machine or lap the valves on the SV ( I have a First Generation). I just did some checks and my valves are too...
I am getting ready to install my flat slides and am wondering if it would be better to make a smaller radiator overflow can or leave the stock one...
I have a brand new set of flatslides (sill in original packaging and set up by Zoran) to install on my 2002 SV 650 that has been sitting quite a...
Hello All, I have been looking at vinyl fence for my yard. I want to do 3 rail. I found one company, only one product that I am comfortable with...
I have a friend that is interested in a Yamaha FJR1300 located in Spartanburg, South Carolina. Is there anyone nearby that might be able to take...
Are these aftermarket needles in my carbs? I seem to remember shims on my other SV carbs. These needles have the a clip and the usual adjustment...
I did some searches and did not find any post concerning the test and tune days this past week. I headed over to check it out and had a great...
I want to pull the cylinders on a race bike I bought a while back, which I have not ridden at all, a real hanger queen. LOL It has been suggested...
How much run-out on a RIM is acceptable ? I purchased two GSXR rear rims at different times and from different people. I machined them to fit...
Separate names with a comma.