Hey All, Wondered what / who everyone is using for RS 125 NF4 crank rebuilds? I know VHM make kits for the NX4s but can't see anything similar for the NFs. I've seen a few posts on using CR125 rod kits and a different small end bearing but nothing definitive. Any advice would be much appreciated! J.
If anyone has the NF4 rod dimensions, that would be super handy - big and little end diameter / width and length centre to centre. It might be the 81-84 CR125 rods and I have the dimensions for those from the Hotrods site.
You can use a cr125 conrod with a different little end bearing (from memory its an RM125 but just check the dimensions)