1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help with bolt removal

Discussion in 'Tech' started by Abiagi, Jan 18, 2008.

  1. Abiagi

    Abiagi Well-Known Member

    Just wondering if anyone has any good advice on removing these two bolts. I am considering an ez-out or something similar, but I am not sure. Any suggestions would be appreciated.

    The two circled in red are the culprits. They belong to the lower side of the idle gear cover. dimensions are 6x30, so I am worried about what I have to work with there.

    [​IMG]
     
    Abiagi, Jan 18, 2008
    #1
  2. YamRZ350

    YamRZ350 Nicorette Dependent

    Drill the heads just enough to remove the cover. Once it's off, you'll have enough of the shank of the bolt(s) sticking out to remove them without much drama. (use locking pliers or similar weapon)
     
    YamRZ350, Jan 18, 2008
    #2
  3. bluebandit2g

    bluebandit2g Well-Known Member

    :stupid:

    Yep, its not like you are going to mess up the cover, grind away.
     
    bluebandit2g, Jan 18, 2008
    #3
  4. Abiagi

    Abiagi Well-Known Member

    Thanks, I will let you know how it goes.
     
    Abiagi, Jan 18, 2008
    #4

Share This Page