Scott, Could you give me the measurements of the H1 rods you sell. I am putting H1 cylinders on my T250 and plan on using H1 rods on the T250 crank. Could you also give me the bigend pin size where it is pressed into the crank? Thanks, -E-
hey eric, we had the h2 rods made, but you can get the h1 rods. sudco of course still has them or use the 440/550 jet ski rod- hot rods or ims and i believe pro-x has them. the pin is not stepped like an h1. the h1 rods are 110mm long bottom end is 15mm wide, the big end pin is 24.6 if i remember correctely. comes with top end bearing that takes the 16mm pin. a kazuki 350 or a susaki........hmm. time to drag fat bastard out again for another round of trash talk. scott