95+ RS125 frame sliders and swingarm buttons

I am making frame sliders that press (hammer) into your swingarm bolt...both sides.
I am also making the swingarm buttons for the 95+ RS125 where your rear stand would go.
Colors are black or white.
Frames sliders are $20 per side and the swingarm buttons are $20 for the pair.

I am also selling pegs and handlebars as well. Not as nice as John Hjelms but cheaper.

Please contact me for info and pictures.
E-mail me at [email protected]


------------------
Eric
Ft Worth, TX
# 377

[This message has been edited by Weezer # 1 (edited 03-12-2002).]

 

Eric, are you going to be at TWS on the 31st? I would like to look at your new pieces.
Andrew Temple
#343 RS125

 

I am planning on going.
Let me know what you need so I can have some ready.
I have plenty of pegs and bars but no sliders.
Thanks!!!


------------------
Eric
Ft Worth, TX
# 377

 

Hey Eric,

I'm assuming you have the sliders on your bike. I wanna check 'em out. I'll be at TWS (CMRA), but will likely only be riding the mini.

 

Eric, I got a plastic 'nut' (M14 fine thread pitch) that I screw onto the threaded bit of the front axle that sticks out further than the axle nut. This has a couple of times saved the axle thread from damage, which is somthng you dont usually think about til you have to change the wheels in a hurry!. The plastic nut usually gets mashed, but so far the axle is ok, crashed on it three times now.

 

Stu....I already have a slider in that too.
I went nuts on my 125.
Thanks



------------------
Eric
EK Motorsports
Ft Worth, TX
# 377