Selling a 2015 MV Agusta F3 800 for a friend. He is selling the bike because he is building a Yamaha R6. The bike shows 1230 on the odometer, but the new engine has less than 150 miles. The bike has never been raced and was only used for track days. The motorcycle was originally a 675, but my friend swapped out the motor for a stroker 840 for more power. This motorcycle had no expense spared with the build, totaling over $29,500. Here are the specifics on the build: Bike was purchased from Moto Forza in 2015 and was a F3 675. 1-owner bike and has the original MSO. All street bodywork has been sold Bike has a 840 stroker motor built by Bruce Meyers of Meyers Performance- dyno put 150 HP to the rear wheel (have receipts for the engine build) Ohlins TTX rear with 10 spring Ohlins front with 10.0 and 10.5 spring - suspension installed by Jeff Stern of Fastline Performance in Las Vegas and setup for 190 pound rider Bitubo steering damper REXXER ECU Flash Meyers Performance also flashed ECU to include auto-blip Full titanium arrow high mount exhaust Brembo RCS19 brake master Brembo Reservoir kit Remote adjuster for RCS Light tech lever for clutch MWR Race air filter CNC Racing rear-sets CNC Racing gas cap CNC Racing clip-ons 53 mm CNC Racing brake lever guard CNC Racing RPS Clutch slider CNC Racing RPS Alternator slider Catalyst racing bodywork DB Holder Fairing stay Tamburini sub frame R & G Tank sliders Woodcraft ignition delete Zero Gravity double bubble windscreen (clear) Shorai lithium battery EK 3D 520 chain The bike has never been crashed. It did have a tip over at 5 MPH, causing damages to the front fairing and a minor scratch on the exhaust. The fairing has since been repaired and re-wrapped. I have receipts for all of the parts. All work on the bike has been done by Fastline Performance or Irish Mike's Performance in Las Vegas, NV. I am located in Las Vegas, NV- please email me with any questions or would like additional photos. Asking $16,000 OBO.
