2015 KTM RC390 Race Bike FS, original owner AFM/CVMA/WERA turn-key

Discussion in 'Bikes for Sale' started by Steven Dawson, Jan 10, 2021.

  1. Steven Dawson

    Steven Dawson New Member

    Hey everyone I have my 2015 KTM RC390 Race Bike up for sale. It was one of the first few hundred into the country, ridden ~200 miles to break everything in, then converted into a race bike with a total of 4 race weekends and 2 track days on it. I have 100% of the paperwork, clean title, meticulous records (aircraft A&P mech), and it has been registered as non-op in CA ever since. Now that I've pretty much stopped racing (work & too fat) its just taking up space in my garage. In theory this could be re-converted back to street, but you'd need to find bodywork & stuff to do it.

    Asking $5500 obo, comes with lots of extras, full build & history below the photos. Located between Santa Barbara and SLO, central coast CA
    Possibly willing to trade + cash for a trackday/weekend bike like a KTM 790/890/1290 or Yamaha MT07/09 or Tenere 700.

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    To be 100% honest, I have a love/hate relationship with this bike, since I have run into and had to fix just about every single problem early model RC390s are known for, but in the process of doing so, have dialed it in perfectly and it is smoking fast.

    Included Parts
    Tyga fiberglass bodywork (minor rashing on LH side)
    Tyga rearsets & levers.
    Tyga rearset spools
    T-Rex case covers (LH side minor rashing)
    Woodcraft brake lever guard
    Moty design 8-cell battery
    Galfer 280mm front oversize wave rotor (same size as cup bike)
    Galfer F&R steel braided brake lines & DOT 5 fluid
    Galfer black HH sintered brake pads
    Andreani front fork cartridges kit for 160-170lb rider
    Ohlins rear shock w/remote reservoir for 160-170lb rider
    Pirelli Supercorsa SC1 110 front SC2 150 rear tires w/2 trackdays.
    Werkes exhaust, recently re-packed by factory
    K&N air filter
    Power Commander Piggyback ECU
    SPAL radiator fan
    1.8 bar radiator cap
    Re-routed harnessing & engine cover for improved airflow
    Insulated bottom of gas tank for reduced heat transfer from engine.
    SPARE - Tyga rearsets, levers and pegs
    SPARE - Brake pads
    SPARE - Stomp grip for tank
    SPARE - Race numbers
    SPARE - Lots of OEM parts removed during conversion.

    History (engine hrs, since odo does not work after removal of ABS)
    2016 Feb - Purchased new from Beverly Hills Ducati (have paperwork)
    2.18.2016 - Changed oil, filter & coolant @200mi, torn down for race bike conversion. Lubricated swingarm bushings, lubricated steering stem bearings, lubricated wheel bearings, removed ABS & street stuff. Installed race fairings. Torque checked & striped all fasteners, drilled & safety wired all required fasteners.
    2.20.2016 - Dyno tune, 1 hr. New tires
    2.28.2016 - CVMA, 3 hrs.
    2.30.2016 - Andreani cartridges installed & set by RaceTech.
    4.29.2016 - Adjusted oil level & coolant levels.
    4.30.2016 - AFM Sonoma, 1 hr run time, blown head gasket
    5.28.2016 - Dropped off with SBM (Santa Barbara Motorsports)
    7.30.2016 - Picked up from SBM, fresh motor and fluids. (Warranty repair, have all paperwork). Found water pump impeller fastener loose, torqued to factory spec. Installed SPAL radiator fan and 1.8bar cap. Found clutch plate basket fasteners loose, torqued to spec.
    10.30.2016 - CVMA, 3 hrs, low side over hill. Replace LH rearset and handlebar.
    10.30.2017 - CVMA, 3 hrs.
    11.25.2017 - Oil & filter changed, battery charged.
    11.26.2017 - Buttonwillow 3 hrs. New tires.
    7.29.2018 - Cleaned bike, charged battery, cleaned/adjusted chain.
    11.26.2018 - Adjusted valves, bled brakes, cleaned bike. Drained old gas, currently empty.
    10.19.2019 - Oil leaked into belly pan from LH side drain plug, replaced gasket & topped off oil. Battery charged. Checked over bike, and started ok.
    6.18.2020 - Bike started ok, sent muffler for re-packing & installed OEM exhaust.
    7.11.2020 - Laguna Seca trackday, oem exhaust passed sound. Battery died.
    7.12.2020 - Cleaned bike, installed re-packed exhaust.
    7.26.2020 - Coolant in oil pan, drained.
    9.7.2020 - Installed improved 530exc seals in water pump PN 77335057000,
    9.12.2020 - Flushed coolant with distilled water & water wetter, flushed oil 2x, new oil & filter.

    Tire warmers & pit bull stands negotiable in sale, email gets fastest response steven.b.dawson@gmail.com
     
  2. Steven Dawson

    Steven Dawson New Member

    New month, new bump, will drop $250 off price!
     
  3. Mohammad Nourmohammadi

    Mohammad Nourmohammadi Active Member

  4. Steven Dawson

    Steven Dawson New Member

  5. the50ho

    the50ho Well-Known Member

    Did the warmers go with the sale?
     

Share This Page