Here is the situation: 04' 999s with the Termi 0.5 systems installed, but NOT the DP ECU ( P/N 96510603B ). So I get the bright idea to install...
Zoran have you had any issues running 87 pump in a stock compression SV motor? I know this has been covered to death, but I was wondering what...
Silent Sport I really like Silent Sport & have used it in 2 of my bikes. Very easy to pack & works well... I got mine through my local dealer...
SV650? Do they make the manual adjsters for 2nd GEN SV650's? Who is a good source? Zoran @ TWF? TIA!
Thanks... Thanks Zoran.. not to get off topic too much in my own thread, BUT is the F3 wheel swap worth doing? (other than tire choice) How does...
One more question... Zoran, Is there any advantage to going with the whole kit? IE master etc... I just found out that the Yammy's use...
Tristan... damm it all to hell.. when I looked at your reply.. I thought "well duh" Man amazing what simple math will reveal... shit hope I dont...
Doohh... ! :o I forgot about the GSXR forks being short... should have thought b4 I asked. The bike is still in pieces... but I should be done...
I have a 06' SV650... Ohlins in the rear & a set of 05' GSXR forks (reworked) on the front. My question is: With the stock rear wheel (160/60) &...
same for an 05' 750? Zoran... The rotors on my 05' GSXR 750 are 300mm correct? So same story for the Yamaha upgrade = 320mm rotors + your...
+1 +1 I agree with TWF. What you really need to do is just sit down for an evening w/ scrap Aluminum & your TIG machine. Remember it is...
Hang in there... G-Dawg, Hang in there sir.... I just settled w/ FED EX over a ground shipment of engine parts ($1700). The good news was I...
For now I am just going to leave the stepper motor connected to the wire harness & tuck it out of the way... BUT at some point I want to ditch the...
Ok so I go to remove my 2ndary throttle plates on my 06' SV650.. then I figure out I can remove the entire assembly & fill the holes... my...
Just wanted to give a BIG thanks & a BIG +1 to George at TrackSideGear! He truly went above and beyond when it comes to customer service...I...
Not to jack my own thread, but what did you think about the quality of the Suomy? I have never owned one... mostly Shoei's my whole life.. but...
I have been told the Suomy's run a bit small & I am wanting a Spec 1R-Extreme... My current lid is a Shoei Picotte RF1000 in medium. Anyone know...
Separate names with a comma.