I have a '96 Ford Exploder that just sits in my driveway 96% of the time. I keep the battery charged, and it normally starts up right away. I went to move it, and now it will not start. The fuel tank is full (I try to keep it full to minimize moisture buildup). Normally, when I turn the key to On position, I hear the fuel pump prime the line. No sound today. The starter turns the motor over with ease but acts if there is no spark. The fuel pump was replaced about 15 years ago when the OEM unit failed. To replace, I have to drop the tank. If the fuel pump is the issue, I'd have to get it to my mechanic to replace - the task is well beyond my capacity. I've yet to check the fuse. If that is OK, what other troubleshooting steps should I take? Everything was fine when I last started it a few weeks ago. TIA.
Probably the pump, a fuse or the relay. On my F. O. R. D. rally car of that era the fuel pump relay is in a fancy integrated box and not a $4 standalone relay. I found one for $15 at a local pull a part. Also for many vehicles of that era...many people remove the rear carpet/mat and just cut a hole in the cargo area to get access to the fuel pump rather than deal with dropping the tank. A quick google search brings up many threads on ford related forums regarding this and usually you can find measurements. YMMV on their accuracy.
I remember reading a post of someone doing that with a pickup that had a bedliner, and I remember thinking I would do it that way too.
Check the inertia switch. This is also a good place to apply direct power to fuel pump to isolate if it’s actually a pump failure, or a relay/fuse issue. Easily accessible, left side of passenger footwell There is also a schrader valve on the fuel rail at the intake manifold where you can quickly check to see if you’re getting any fuel pressure
My experience with in-tank pumps is that they either work or they don't, you don't get any warning that they're going bad.
Trip and reset the Inertia switch. If that doesn’t do it make sure you are getting power leaving it going to the pump. If so it’s probably the pump itself. Provided it has a check engine light KOEO. Check that first.
If it's the pump itself, they slowly die, you just don't have a way of knowing unless you've got a fuel pressure gauge that you're monitoring.
If you determine the pump is not running, last resort bang on the tank with a mallet (or 2x4) while someone cycles the ignition key I’ve encountered stuck pumps if they’ve been sitting awhile, especially if there’s any moisture in the fuel I know, it sounds red neck, but it’s worked
Yep. I had a Explorer as a work vehicle and this method got me out of a couple jams in order to get me home. I took my shoe off and smacked it with the heel. There is no sign they are going. They just quit.