1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Safety wire question (again)

Discussion in 'Information For New Racers' started by McGixxer, Feb 15, 2012.

  1. McGixxer

    McGixxer Well-Known Member

    Okay, my check list is getting small, but I need a little clarifcation on brake lines...

    Do I have to drill and wire my brake line bolts?
     
    McGixxer, Feb 15, 2012
    #1
  2. Boman Forklift

    Boman Forklift Well-Known Member

    No, just the bolts used to bolt on the calipers to the front forks.
     
    Boman Forklift, Feb 15, 2012
    #2
  3. primo

    primo Well-Known Member

    I don't want to open a new thread so I'm asking here. Mongo can we use K&N oil filter without a hose clamp? I have my K&N pre-drilled safety wired at a place that will not move. I don't see a way that it can get loose or leak. I thought you could use the K&N without a hose clamp but I want to be 100% sure. Thank you.
     
    primo, Feb 26, 2012
    #3
  4. Tdub

    Tdub Say what???

    :up:
     
    Tdub, Feb 26, 2012
    #4
  5. Mongo

    Mongo Administrator

    The K&N without a hose clamp is fine. Just as with everything make sure the wire is pulling it tighter.
     
    Mongo, Feb 26, 2012
    #5

Share This Page