1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Question about quick shifter sensor testing

Discussion in 'Tech' started by fzgixxerman, Jan 21, 2009.

  1. fzgixxerman

    fzgixxerman AKA Mark Byrd

    I just received my quicker shifter sensor. And I wanted to check it to see if it was working for I installed it. Install one end to the table and pull out on the other and I was surprise at the pull force it takes to close the switch. Is this normal?????? It is a pull type sensor. thanks for the help, first one I have tested.
     
    fzgixxerman, Jan 21, 2009
    #1
  2. HD1911

    HD1911 Johnny Rocket

    Yes it takes a good amount of leverage to test it while it's off the bike.
     
    HD1911, Jan 21, 2009
    #2
  3. fzgixxerman

    fzgixxerman AKA Mark Byrd

    Thanks bro!!!! I was a little worry.
     
    fzgixxerman, Jan 21, 2009
    #3
  4. HD1911

    HD1911 Johnny Rocket

    No prob :up:
     
    HD1911, Jan 21, 2009
    #4

Share This Page