flash tune R1 dynojet sensor

I have a flash tune R1, I want to know how to connect the QS dynojet sensor, I already know the pin from the ECU but the sensor has 3 cables.
I want to know how to connect them

thanks

[email protected]

 

Blue and green. Doesn't matter which goes where. It's a switch.

 

and the red one????

 

You will need normaly open PC 3 sensor with two wires.One goes to the ground and the other one goes to the pin on ecu harness conector.
Maybe there is the way to conect 3 wire switch but I don't know,contact Huey and he can
hook you up!

 

Ive never been able to fiure out how to use the Bazzaz sensors. I alwas use PC-3 sensors. The Normally open push or pull to close ones. Then what Mike says is true.

 

The red wire is not used.

 

The Bazzaz sensors have to be powered up to work. At the heart of them is a Turck 4669500 proximity sensor, Google that and you are on your way.

 

Is the same switch regardless of Pull or Push?

 

On the new ones yes