Cbr600rr STM Slipper

Discussion in 'Tech' started by Ethan Wakefield, Apr 12, 2022.

  1. Ethan Wakefield

    Ethan Wakefield Active Member

    BC0D1B40-E852-4372-87BD-4E5BB0277709.png B0279C1E-1E98-4285-9D9B-85FC7F9E4BBD.png 46A45D4E-5333-4B92-84E9-7949DB68A071.jpg BC0D1B40-E852-4372-87BD-4E5BB0277709.png B0279C1E-1E98-4285-9D9B-85FC7F9E4BBD.png BC0D1B40-E852-4372-87BD-4E5BB0277709.png B0279C1E-1E98-4285-9D9B-85FC7F9E4BBD.png I believe my Cbr600rr uses a different specialty tool than the tool posted in the US instructions.

    Does anyone have the 008amy002 tool? It look like it’s going to pretty much be a 36 mm Allan wrench. If you do could you measure it for me? I was going to make a tool with some hex bolts, but need to get the bike together asap. So I’ll probably refresh it at a later date.

    Attached pics. US instructions, instructions I found online with different tool, picture of the clutch
     
  2. Suzuka_joe

    Suzuka_joe Well-Known Member

  3. RM Racing

    RM Racing Tool user

    I would start measuring large nuts and make a tool out of one with the closest OD.
     
  4. Matthew Patacca

    Matthew Patacca MaTPaT218

  5. Suzuka_joe

    Suzuka_joe Well-Known Member

  6. RM Racing

    RM Racing Tool user

Share This Page