2013 Yamaha R6 -$8,250 Located in DFW area This bike won multiple CMRA Expert championships for 2022 including Middleweight #1, C Superstock, C Superbike, B Superstock, and B Superbike. This bike also ended the year CMRA expert overall #2. This bike is fast and dialed in! I bought this bike from the original owner back in 2017. The bike was purchased and immediately converted into a track bike and only used a couple times a year before I bought it. Since I acquired the bike all work has been done by Jimmy Cambora (Raceworx) or by Steve Upchurch (RES). The bike was never registered so I have an MSO. The forks and shock were refreshed and serviced in-between every race season by Jimmy Cambora since owning the bike. The engine was completely rebuilt in 2019. I replaced multiple parts for the 2022 season. Front brake calipers rebuilt and new ti caliper bolts. Front rotors and bolts replaced on both front wheels. Samco coolant hoses installed. New Water pump. New steel front and rear brake lines. New clutch cable. New vortex fuel cap. Jimmy replaced steering, swingarm, and wheel bearings. New dynojet push/pull quickshift switch. Parts list: Front suspension - AKGAS traxxion dynamics Rear shock- Penske triple (will be freshly rebuilt with 0 miles!) Bazzaz z-fi tc (1 pump gas map and 1 MR12 fuel map) Translogic autoblip up/down quickshifter Dynojet push/pull switch Renthal clip ons Vortex rear sets Vortex fuel cap Vortex sprockets Vortex road racing chain Ohlins steering damper Brembo 19x18 master cylinder M4 full exhaust Slipper clutch spring modification Vesrah ZZ brake pads Sharkskinz superbike bodywork (see description at bottom) GB case covers Gutted thermostat Safety wired for CMRA racing Spares: 2 sets clip ons (1 vortex, 1 renthal) Fairing stay Front wheel with rotors Rear wheel with rotor New vortex 45 rear Used Rental 43 rear Used rental 47 rear Front axle nut Front sprocket nut Rear axle nut Oil dipstick Shift rod Seat pan (cracked) Clutch lever (used) x2 Clutch cover oem Clutch cover gasket x1 Generator cover oem Generator cover gasket x4 Timing cover gasket x1 Used steel brake lines Radiator cap x2 Brake reservoir bracket Vortex Shift side rearset Vortex Brake side rearset (scrapped peg) Gb clutch cover Gb timing cover OEM R6 seat Seat mount Front fender Supersport tail (uses oem seat) Gas tank (dented but functional) Fuel pump (used) Fuel pump gasket new Water pump (used) Radiator (used) Subframe (used) Push pull shift sensor translogic (used) Rear caliper holder Windscreen (used) OEM Air filter Front sprocket 15 Pirelli rain tires front and rear The only negative with this bike is the bodywork is rough. It is sharkskinz so it is good stuff and can be repaired. The upper is in the worst condition and is cracked in a couple different places. The lower is scrapped. The tail has a crack and some scrapes as well. I've been racing with it as is with the anticipation of repairing it over the winter. PM me if you are interested! Facebook ad with photos: https://www.facebook.com/marketplace/item/718082322993741/?mibextid=dXMIcH