2008 GSXR1000 Engine: +4mm stroker

This engine was dyno tested and then put on the shelf as a spare and never used.
Built specifically for car racing but will work in a motorcycle application with a different oil pan.
Billet +4mm stroker APE crank / Carrillo rods / Custom JE pistons / Yoshimura cams and springs / Ti retainers / Ported head with +1mm valves / APE head studs.
Will run on any fuel 100 octane or higher.
$7000 cash. Will ship anywhere.
[email protected]

 

That torque curve... There really is no replacement for displacement!

-T

 

Speaking of displacement, the bore size is 75mm and the stroke is 63mm for a total displacement of 1113 cc.
This motor also has a Yoyodyne slipper clutch.

 

Was it dyno'ed in a car or bike? The wheel HP and torque is, with due respect, middling at best for all the mods and displacement.

 

Hey Jon,
You guessed it, it was in a car when dynoed. Two tires, 9” wide each.

 

Sold