Can someone tell me what the torque specs are for the axle nuts front and rear on Honda RS125. It's a 2004 style if it matters. Thanks in advance.
I need a new rad cap on FZR400 and new one is like $48 or some such. Is there a good alternative?
Wheels/Rollers I've been trying to figure out a good way to carry spare wheels with rains, any good ideas there? Carrying them in the back seat...
I ran Motul 300 V (full synthetic) 5-30 in my 2006 R6 for three seasons and never had any clutch or other problems at all. Does thinner oil...
Thanks Thanks. That all sounds good.
How do I ditch the key from my FZR400 gas cap? Can't find an aftermarket keyless gas cap for an FZR400 - does the one for the FZR600 fit? Thanks.
Aluminum Rad I ran an aluminum rad I think it was for a go kart, on an FZR400. It was about the stock width and tabs were welded on to make it...
Flywheel? Flywheel? Please send pm if you have it for sale thanks.
FZR400 I raced an FZR400 about years ago and the bike came back to me this fall, and I'm prepping it again to race alongside my other bike....
Thank you all for the information on the aluminum sleeve, sight glass and plumbing part trick, it is very helpful. Matt, I've emailed you at MD...
I had posted this on vintage but should have posted here: I am permanently removing the starter, starter clutch and associated gears from my...
I am permanently removing the starter, starter clutch and associated gears from my 1990 FZR400 1WG and converting it to total loss (removing...
Separate names with a comma.
