Depends on the year. I have had early R6+R1 forks on 1st gen and was very happy with results. I think later R6 forks were shorter and may be an...
Stop by the Atlantic Roadracing booth if you get a chance. Some of the local racers will be there, maybe even some that are on this site....
41mm flatslides for sale. Purchased form Zoran a few years ago. Very good condition with probably only 600km on them. $750 for the flatslides...
I have been using this for a few years. http://www.princessauto.com/en/detail/5-litre-oil-flask/A-p8492605e
Stock SV's have one Vacuum operated pump that feed carbs when its running. Your bike appears to be setup with 2 pumps(one for each carb) zip...
R6 brembo is 16X20mm. Could not find pivot to piston plunger distance documented anywhere, but 20mm is what I measured in the garage.
Orion website has all Pirelli dimensions and Dunlop website has theirs....
They have machines where they can run the tires under load and probably measure every little detail. In an older kawi motogp vid they show a bit...
I have switched to r6 master with gsxr caliper and it is fine, actually better than suzuki master. There are a few brake ratio calculators out...
Looking for cartridge kit for 06-10 GSXR600 cartridge kit. Ohlins , GP, ktech. I would consider complete forks with kit as well.
I believe they are 11/16- 20TPI. You can go to penske website and under tech section look up parts diagram for the shocks and get the info....
I use a pair of lock ring pliers similar to these. Quick easy, no damage to pads....
Very dark clouds, a few rain drops. Oh Boy.
Separate names with a comma.
