also same with rear brake, spread the pads out or remove. and test spin, only do 1 of these at a time though to isolate the issue, as well as the...
steg pegz https://stegzmoto.com.au/collections/ktm/products/steg-pegz-ktm-sp72-2020-exc-excf-xcf-w-xcw-125-500 and squeeze your legs.
it was an ATTACK airbox, i used some air conditioner foam wrapped around the front before the scoop. and the zx7 spacing wont be even close. i...
all the dodge and ram products are canbus, hit a scrap yard and pull one fronts are small. cheap way to try
if your going to leave the car for a while, get a cheap solar charger, not only does it charge but helps warm the battery up. I only drive my...
hint if your running FCR's and the airbox. get yourself a set of stock 2003 gsxr 1000 rubber V stacks, made a 10HP diff on mine vs no stacks
be gentle..........
drill where the pins used to be in the plastic, insert a small screw, then cut said screw to length, just make it close to the hole size in bar.
take the pads out and place a block of steel in there or wood or something solid. see if lever gets firm. if so, pads are bent. in expremly used...
large nuts and bolts, compressed air to toss them around/ remove chips and dust. muriatic acid and some water over nite.it will be shiny clean....
batter back up with a secondary pump is the way. I got this tied in above my main one. with vertical float, off amazon. with a 1000ca deep...
i have an expansion module if required. if its a pc3 or 5 its needed
ive crossed multiple times to ride in the south, sometimes they take inventory of what's in the trailer vins included. sometimes dont even get...
https://eclecticproducts.com/product/amazing-goop-automotive/ stuff really is amazing. ive done all kinds of fixes that shouldnt have worked, but...
not saying this is the issue. I am useing a 2008 gsxr600 to teach on long flowing corners i would open the gas fast and get a slight stumble....
Separate names with a comma.
