Safety wire question (again)

Discussion in 'Information For New Racers' started by McGixxer, Feb 15, 2012.

  1. McGixxer

    McGixxer Well-Known Member

    Okay, my check list is getting small, but I need a little clarifcation on brake lines...

    Do I have to drill and wire my brake line bolts?
     
    McGixxer, Feb 15, 2012
    #1
  2. Boman Forklift

    Boman Forklift Well-Known Member

    No, just the bolts used to bolt on the calipers to the front forks.
     
    Boman Forklift, Feb 15, 2012
    #2
  3. primo

    primo Well-Known Member

    I don't want to open a new thread so I'm asking here. Mongo can we use K&N oil filter without a hose clamp? I have my K&N pre-drilled safety wired at a place that will not move. I don't see a way that it can get loose or leak. I thought you could use the K&N without a hose clamp but I want to be 100% sure. Thank you.
     
    primo, Feb 26, 2012
    #3
  4. Tdub

    Tdub Say what???

    :up:
     
    Tdub, Feb 26, 2012
    #4
  5. Mongo

    Mongo Administrator

    The K&N without a hose clamp is fine. Just as with everything make sure the wire is pulling it tighter.
     
    Mongo, Feb 26, 2012
    #5

Share This Page