So I got the blip assist and the quickshifter for my track bike. Last night I get around to the install. First things first, route the brake sensor up to the front brake and install. Easy, done. Next... Connect the Acceleration position sensor to the Blip assist. Got it, done. Now I have two wires left on the Blip assist, one which goes to the ignition coils (assuming so since its listed as power and RPM sensor cable on the diagram) and the other that connects to the quick shifter im assuming? Now for my first problem.....the quickshifter harness has 4 piggy back connectors that route to the Ignition coils. But I also have the additional one on the blip assist harness? Im so lost. I can post any pictures if it would help me get this figured out. Thanks in advance!
I'd assume the blip assist would would interrupt the throttle body servo motor instead of the ignition coils. But I can't look at the installation instructions without a serial #.