1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

showa comp valve shim ID

Discussion in 'Tech' started by FatCat, Aug 25, 2009.

  1. FatCat

    FatCat Well-Known Member

    Looking for the ID of the shims used in a '03 GSXR 750 Showa fork compression valve.
     
    FatCat, Aug 25, 2009
    #1
  2. Dr. GoFast

    Dr. GoFast Well-Known Member

    didn't those bikes use KYB?
     
    Dr. GoFast, Aug 25, 2009
    #2
  3. FatCat

    FatCat Well-Known Member

    1000 was the KYB
     
    FatCat, Aug 25, 2009
    #3
  4. banzai132

    banzai132 Oh shit! not again!

    Which shims? They start small and get gradually larger.
    The largest ones OD is .670" Not sure about the ID.
    Corrected .240" ID.
     
    banzai132, Aug 25, 2009
    #4
  5. beathiswon

    beathiswon Well-Known Member

    04-05/600-750 Showa's use 11mm I.D. I'm pretty sure the 03's use the same size. Sorry I can't give a better answer than that.
     
    beathiswon, Aug 25, 2009
    #5
  6. FatCat

    FatCat Well-Known Member

    That is what I needed. Thank you.
     
    FatCat, Aug 25, 2009
    #6
  7. TWF2

    TWF2 2 heads are better than 1

    nope, they are all 6mm ID.
     
    TWF2, Aug 26, 2009
    #7
  8. beathiswon

    beathiswon Well-Known Member

    Crap!! TWF2 is correct!!! I read my caliper wrong. Sorry about that FatCat. Hope that didn't cause any problems.
     
    beathiswon, Aug 26, 2009
    #8

Share This Page