I am looking for a way to use just the ignition wires to make a switch for starting my bike 2009 Yamaha R1/R6 (same ignition wiring). Currently I'm using the hot wire from the ignition and crossing it to the kill switch and it works, but I do not want to use kill switch to power and stop the bike. I have made many of these for people on the R1 forum using a few different options to add a little security. here is one of the ways I have made them: http://flic.kr/p/abgHBr Here is a link to what is setup on my bike now and a thread I started when I had some extra material" http://www.r1-forum.com/forums/showt...407&highlight= My reason for wanting to use the ignition wires is because on the 09+ R1 and maybe the R6 you can not go into DANG mode (self diagnostic mode) with the current setup. If someone could please PM me with a set of plans or instructions it would be greatly appreciated. Thank You... PS If my integrity is questionable because I am a new member with few post, please visit r1-forum.com my screen name is the same and I am a very active member with positive feed back.