Can someone please tell me what eror code #30 are for the 2003 R6, My bike won't start, Thanks............
lean angle sensor.... Tester positive prove blue Tester negative prove yellow/green 1 2 Fault code No. 30 Symptom The motorcycle has overturned. Used diagnostic code No. 08 (lean angle cut-off switch) Inspection operation item and probable cause Operation item and countermeasure Reinstatement method Defective lean angle cut-off switch Replace if defective. 1. Remove the lean angle cut-off switch from the motorcycle. 2. Connect the lean angle cut-off switch coupler to the wireharness. 3. Connect the pocket tester (DC 20 V) to the lean angle cut-off switch coupler as shown. 4. When turn the lean angle cut-off switch approx. 65, the voltage reading is 1.0 V to 4.0 V. 5. Is the lean angle cut-off switch OK? Reinstated by turning the main switch ON (however, the engine cannot be restarted unless the main switch is first turned OFF). The motorcycle has overturned. Raise the motorcycle upright. Installed condition of the lean angle cut-off switch Check the installed area for looseness or pinching. Connected condition of connector Inspect the coupler for any pins that may have pulled out. Check the locking condition of the coupler. If there is a malfunction, repair it and connect it securely. Lean angle cut-off switch coupler Main wiring harness ECU coupler
