1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Graves Diamond Frame Silders

Discussion in 'General' started by Chand, May 12, 2020.

  1. Chand

    Chand Well-Known Member

    Has anybody used these and recommends them ?
     
    Chand, May 12, 2020
    #1
  2. Zoomie

    Zoomie Well-Known Member

    Just installed a set on an RSV4 Factory 1100 today, very impressed.
    Have installed lots of R&G, etc.
    This Graves set up was a step above. Nice stuff.
     
    Zoomie, May 13, 2020
    #2
    Chand likes this.
  3. gixxerboy55

    gixxerboy55 Well-Known Member

    Kinda expensive, limited availability.
     
    gixxerboy55, May 13, 2020
    #3
    Chand likes this.
  4. Chand

    Chand Well-Known Member

    Thanks! I was wondering if it would actually do much in event of a crash.
     
    Chand, May 13, 2020
    #4
  5. Chand

    Chand Well-Known Member

    Yeah, it’s about $265 ..
     
    Chand, May 13, 2020
    #5
  6. grasshopper

    grasshopper Well-Known Member

    Frame sliders can snag and can do more damage sometimes than without them. Just food for thought
     
    grasshopper, May 13, 2020
    #6
  7. rabbit73

    rabbit73 Scheiße

    I have them on my R6. PO tested them in a low side and they held up well. Slider, peg, and the end of the exhaust can were the only damage.
     
    rabbit73, May 13, 2020
    #7

Share This Page