Bent trailer

I bent the tongue tube on my Kendon style USA trailer. Didn't realize it was bent until pulling it out to show a buyer. I towed it that way 150 miles and never noticed it. Do you guys think it can be bent back and not effect the integrity of it. If so, any ideas on how to bend it back? Thanks.
Bent it by backing it up with nothing loaded so I couldn't see it. And forgot it was there. Old man syndrome. Jack Knifed it backing up against the car bumper.

 

Post a pic

 

sounds like an excuse to bust out the torch...

 

Jack-knife it the opposite way.

 

Yea, definitely picture of it to see how far out it is. Probably isn't going to be a huge deal with such a small trailer just to bend it back if it's only a little off or just don't do anything with it.

 

BMFH.

 

I actually thought about that.

 

This

 

Hard to tell from the pics but is that center tube welded to the others? If not, remove and replace?

 

Message Britt here on the board,he is the welder/metal messiah.

 

I wouldn't straighten that, I think that tube is junk.

 

yea u got u a bit of a twist in there with thick looking paint/ powder coat...dont torch that without grinding

 

With someone else’s vehicle