Have you checked on ebay? Im seeing blocks for resonable prices!...
Sorry I missed the part where you said it hit the cylinder. If the bore is destroyed then I would agree just change out the block. If the damage...
Its aluminum, its not like a cast iron block that would make it super difficult to weld. If you were to fix it, just make sure its fully fully...
Maybe the issue is European spec vs US spec? Because my R6 is European spec, and there are differences in the stock bikes. Like for instance the...
Will was the best!!! Super nice guy! I remember I used to buy damaged wheels and send them all to him and no problems they would come back...
Hi, guys! Anybody know where I can get a good deal on an alpinestars suit? Ive checked fc moto and motocard. They do have great prices, but just...
If you have a aluminum bit, you can cut and shape it to a bung and simply drill and cut threads into it. Then find a good tig welder and just weld...
Grab all the bolts, loosen up the triples, top clamp, wheel axle, pinch bolts, brake calipers. Make sure its all loose, with the bike on a rear...
2.5 bar or 36.2 psi front cold 1.5 bar 21.7 cold rear. On a gripped, abrasive track 65-70f track temps
Off topic question what tire psi are you guys running on the new V4? Ive been running 36 front cold and 22 rear. I was running this tire psi on...
My opinion, I would stick to 180 rears on a 600cc, its a lighter/cheaper tire, wont need much geometery changes until you pickup more speed. sc1...
Every time I replace my pads, I lightly scuff up the rotors with sand paper I agree, grease is bad! But the amount I use is very minimal. I...
I actually figured out the issue, previously when I replaced the brake fluid I forgot to bleed off the master cylinder screw. When I replaced the...
Yup abs deleted 17 R6 braided brake lines. I always clean the calipers, and very lightly rub tiny bit of grease on the moving parts. It was just...
I agree! some pricey fluid! Maybe ill try the motul, because the fluid I used wasnt intended for racing.
Yesterday during a race, I somehow over cooked the front brakes and completly lost the front brakes. The brake lever just went to the grips on a...
I race in the middle east, my buddies in losail many practice on rental (for racers only) 300cc or 400cc ninja with full ohlins suspension and...
Ive never tried supermoto, I do tour on a bmw R1250gs. Thats actually helped me a bunch with rear brake pedal feel. Doesnt SM require a bunch of...
Also suzuki 300cc
Need some advice, im looking for a up to 300cc track bike, to run on a supermoto track there limit is 300cc. Theres R3, Ninja 300, cbr 300....
Separate names with a comma.