Anybody have any recommended gearing numbers for this track. I haven't been in about 3-4 years and used to run +1 tooth rear from Tally gearing...
What did some of you guys use? I have a good base line for Tally, looking for the right gearing from that starting point. My Tally gearing gets...
Can someone be so kind and generous as to run me one on this: 1J4FY19S4WP741758 And thankyou again,
Trying to look at the trackdays scheduled for TGPR and the domain name has expired. Anyone know where their website is now?
What are you guys using on the Michelin Pilot Slick as far as tire pressure? 120/180 combo, med-soft front and rears on an R6? These are not the...
Anyone know if the same suspension ride height #'s work for the 03 bike as they did for the 99-02 bikes and what kind of gearing are you guys...
What did some of you guys use on this bike for gearing at Talladega? Never been there with this bike. Thanks.
Any ideas on the cause of this type wear? Set-up:New bike, not sure of spring rates. Was told it was set up for 180-190lb person. I weigh...
Take a look at the parts for sale and see if I listed the right model for Ronnie's tank. Thanks.
What is a good gearing for an expert rider on a 2004 GSXR-750 at Jennings. Bike has full suspension set-up and some motor work. It makes about...
When was the last time that you replaced the clutches in the hawk? And what kind did you use, if you can remember? I have the cover off and...
I posted this question in the general but it may be better suited for this forum. Anyone have any experience using aluminum friction plates in...
Anyone have any experience using aluminum friction plates in their clutches. I was thinking about trying some out in a Honda Hawk. I put a...
Can someone tell me how many mm's the stock fork tube came up thru the top of the triples. I'm trying to figure out the starting point before...
I may have to call Max but does anyone know if he still uses 5mm fork extenders in rebuilding new GSXR-750 forks. I know that he extended the...
Does anyone use a 1/4 turn throttle on their GSXR racing right now. Trying to get some feedback for a friend. I know that they use to make them...
Sold my old Micron about 2 years ago and never had any trouble with it. Need to get a new one. I like the XT or whatever this new thing is but...
I need some gearing suggestions for a hawk 650 at Jennings. Bike makes 50ish HP. Need suggestions for a professional novice:D I have not had...
Will someone measure the length of a stock shift lever linkage rod for me? I have changed the setup on a set of rearset adapter plates on a hawk...
Will someone measure the length of a stock shift lever linkage rod for me? I have changed the setup on a set of rearset adapter plates and needs...
Separate names with a comma.
