06 honda 1000rr cam cap torque specs, thats what I need to know. thanks
honda cb 360t 1976, been sitting for a while. not running and no title. looking for 300.00. kicks over give me a call at 717 926 0117 bike is in...
http://www.growbot.com Crazy!
I sold some rentals last year and have enough to pay off the duplex I live in. I would make 600 a month with the rent. That would cover almost all...
Just got this money pit together after 3 years. Motor complete rebuild from the crank up. So I have some start up questions. I want to pre mix the...
Bike was low sided on the left side. gauge cluster light up but no speedo, tack, or odometer reading. signals and light work. wire harness shows...
Got my bike to the track early Sunday morning and pitted next to Bruce Egan and his son Brian Egan. I went out for the first practice and got to...
Well this project has gone on for about 2 years and I am close to the end. But I have a bad stator. Any leads would be great I have seen some on...
Took my dog to my buddies house to work on his kx450f. Got the bike done and had my dog ginger in the house for about 5 mins. fluffy came down the...
von helmut in canolli's trailer at summit point. If you remember bobby kim got his toenails painted black but von helmut sat on canolli's pillow.
Is there any difference in doing a leak down test at tdc and bdc. I am working on a 05 rmz 450 and could not get a correct reading because the...
someone stole my taillights out of my 95 nissan pick up last week. I guess the economy forced this. If anyone can help me find a set off of...
I sold my kx 250 and was recounting the legal tender I received. Looking close at the bills, Hamilton, Lincoln,, Franklin and Grant. I said to my...
I have a bunch of 1984 gpz 750 parts that I want to get rid of. If you are going threw Harrisburg pa via the turn pike I am 5 mins from the exit....
I have a 2003 800 ss with a bad trans. what other motors will bolt in and will I need the ecu if I change the engine size?
I just picked up this beauty. a 74 h1, its been sitting since 78. All the pistons are stuck tight. Any advice on getting them unstuck would be a...
I was looking to buy a used glock 26 from a private seller. He said it was fired at the range under 10 times.It looks very clean. What wears out...
I called Citibank today after finding out my APR was 11.24 to complain about the increase in the rate. I talked to someone with an Indian accent...
Want to waste some time other than reading bbs posts? http://fantasticcontraption.com/
Im looking to buy a good MIG/TIG welder for around 2000. Does any one have any suggestions or experience on welder brands and models. thanks.
Separate names with a comma.