2010 6x12 (plus v nose) enclosed trailer. 6’6” height, insulated and finished roof, has a switch operated light, interior 110v outlet, interior...
Wasn't sure if this should go in tech or not but it seems more fitting here. What size axle from and rear does a honda nsr125 use? I have looked...
Doing a search for cylinder honing I see that mos use a brush hone.... What grit hone should I get? As always thanks for your input!
Where the heck are the adjusters for preload? I have searched and searched on line and cant find crap! I know there has to be a ton of dirt bike...
I am the recent owner of a 08' R6 and have become a traitor to Honda. lol I like doing research on what the differences are through the...
BACK GROUND, 2007 CBR600RR. Actual milaege unknown. stock bottom end and refreshed top end (valve job, valves, seals). At idle it will misfire...
An awesome weekend! Thank you to Ballistic Performance Components, DP Brakes, Optimal Race Fairings, Honda, Pitbull, Vortex, and Mike Fitzgarald...
My question is for the tuners.... I have a 2012 cbr600rr with a bazzaz unit. Its tuned for pump and mr12. Would I get any gains switching to a...
I have a 2012 cbr600rr and I had an issue that started at Nola. On track at pace the temp hit 217 deg F. I came in and inspected for leaks and...
Pros and cons of a single line with a 'T' v.s. a dual line setup? More feel from the single line but more power from the dual line.....?
I have a 96' Honda cr80r and it will not run right. It will start and idle but as soon as any throttle is applied it falls on it's face and dies....
I have a 2012 cbr 600rr. The front brakes seem to drag way to much. When the front wheel is spun it maybe turns 1/8-1/4 of a revolution and...
How are front brake rotors supposed to be installed? The left vs right rotor, should the carrier spokes be aligned with one another or offset?...
At the end of last year I decided to build and engine and after realizing that it was not in my budget to pay someone to do it I decided to take a...
I finished up the rebuild on my engine this weekend (thanks for all the input everyone). Now I've never installed a mcct. Instructions read...
I don't know if it is all manufactures. Every honda engine I've ever replaced a bearing in The bearing has a light gray surface color (makes me...
What type of oil should I use during break in of a freshly rebuild motor? I was thinking rotella and GM eos.
If I send my block to Millennium Technologies for repair (nickel-sil), new oem pistons stock bore. Will it still be considered SS legal?
What is the best way to clean crankshaft oil passages? I was planning on useing solvent and a gun barrel brush and compressed air. Is there a...
Is this the right place to post this right???? Would any dealers be interested in selling a bike at cost to sponsor a rider???? Looking for a...
Separate names with a comma.