For sale awesome turn key 100% trackday/race ready 2019 Yamaha MT-07RR! Performance: 82 rwhp <345 lbs, final engine build/tuned at Pro6 Cycle by Craig A. The bike was built this winter with only ~1000 KMs on the dash ONE owner, no corners cut. The bike was built with the intent of racing it as it's basically BRAND NEW! Engine: March 2020 Dyno engine break-in @ Pro6 Cycle March 2020 Dyno @82 rwhp on 91 pump gas Yoshimura's R-77 Works Finish Full System Yoyodyne Slipper Clutch AS3 race spec silicon hoses Wiseco piston kit Carrillo rods Robem Engineering FZ-07/MT-07 Lightweight Starter Clutch Hordpower airbox TWF Racing (Zoran) bored throttle bodies TWF Racing (Zoran) porting TWF Racing (Zoran) WebCams grind 101/207 R&D transmission undercut Electronics: aRacer RC Super2 Race Package includes the following items: RC Super 2 ECU AF1 wideband module Quickshifter 1 to 4 cable Modified wiring harness (keyless ignition) Chassis: K-Tech DDS Pro rear shock Öhlins Road and Track NIX 22 front cartridge kit Robem Engineering FZ-07/MT-07 Adjustable 41mm Triple Clamps @26mm offset insert AP MotoArts Gen 2 FZ-07 Linear Linkage AP MotoArts Sub-Frame Misc: Woodcraft Clip-ons Renthal grips Vortex billet locking fuel cap Renthal 520 Ultralight sprockets and chain TXP adjustable billet rearsets Shorai LFX Lithium Battery AP MotoArts custom bodywork R6 Front Brake Master Cylinder Core Moto SS brake lines and banjo bolts Fresh 0 km complete paint job Dunlop race slicks KR448(0129) 120 and KR451(0455) 180/60 2 extra sets of spare rims with disks (front and back), yellow and black Bolts drilled and lockwired Rear Brake Reservoir Delete Kit Bickle Aluminum brake guard (not installed in pic) $15000 CAD https://www.kijiji.ca/v-sport-bikes/ottawa/2019-yamaha-mt-07rr-track-race-bike/1494579983
Before I get to enthusastic, do you know what would be the process to import to the US? What is the title status? Why selling after all this effort and money? has it been tracked or ridden since the build was completed? As to the transmission, you stated it has been undercut. Is that enough to fix the known issue of the quickshifter not allowing shifts from 4th to 5th gear or did you also install the shim kit? Thanks, Dave
Oh man!! If this were in the US I’d be all over it. Getting it to the states right now will be pretty difficult. Good luck with Sale.