Rear MC Return Spring Setup

Discussion in 'Tech' started by Tractionless, Aug 26, 2009.

  1. Tractionless

    Tractionless Well-Known Member

    I know a return spring isn't necessary; however, I'm picky and would like to use one with my Woodcraft Rearsets. Does anyone know where to source the spring setup in the 5th pic. of the following thread? http://forums.13x.com/showthread.php?t=225016

    I did PM the OP, but I know some guys only use this forum to sell parts so I figure I'd post where the locals roam as well.

    Thanks for any help you can lend.
     
  2. fastfreddie

    fastfreddie Midnight Oil Garage

    i used a clutch spring.
     
  3. RIB333

    RIB333 Well-Known Member

    Woodcraft CFM sells those, I'm pretty sure.
     
  4. beathiswon

    beathiswon Well-Known Member

    I've seen hardware stores such as Lowe's, Home Dep, Ace etc. that carry individual springs in sizes that would work for MC's.
     
  5. hcr25

    hcr25 Well-Known Member

  6. GixxerBlade

    GixxerBlade Oh geez

    great idea!
     
  7. TWF2

    TWF2 2 heads are better than 1

    I take them out of thermostat :)
     
  8. Mr Sunshine

    Mr Sunshine Banned

    And that's after you've taken your thermostat out of your bike right? :D
     
  9. TWF2

    TWF2 2 heads are better than 1

    funny how that works, take out guts out of thermostat and nice spring falls in your hand :)
    you do need to make plate for spring to use it on master, woodcraft is easy and cheap.
     
  10. Tillerpilot

    Tillerpilot Well-Known Member

    I have all of the colors shown. $14+$2

    Thanks for asking.

    [​IMG]
     
  11. Tractionless

    Tractionless Well-Known Member

    Thanks for the replies, looks like alot of options including Yoshi. as the OP answered back my PM.
     
  12. SlowSteve

    SlowSteve Habitual User

    Bump for Jim, awesome parts and fast shipping too.:up:
     

    Attached Files:

  13. Tillerpilot

    Tillerpilot Well-Known Member

    Thanks, I was hoping someone would post up. Enjoy.
     
  14. Tractionless

    Tractionless Well-Known Member

    Bump 2 for fast shipping, no hassles, great price, and seamless install!! :up:
     
  15. IrocRob

    IrocRob Well-Known Member

    :up::up: for the parts made by Tillerpilot
    A fair price and fast shipping; can't beat that.

    I bought a few of his rear caliper "springs & washers" last week and
    he mentioned that he also has custom made resevoirs that will fit
    my bike; a 2003 GSX-R1000. I suspect these would fit many other
    GSX-R's as well, but that's for you to determine if you are interested.

    Received it today and can not say enough about how well made this part is.
    Easily rivals anything you would find from any other source.
    Solid aluminum resevoir and cap, black anodized; also included are the
    necessary rubber seal and vent ring.

    The tygon hose may be a cheaper alternative, but it's nowhere near as
    nice as this part.
     

Share This Page