Actually, Yuengling is far better than that Lite/Light shiite half the world seems to drink.
A Harley "death wobble" cost me 4 teeth and a lot of skin back when I was 18.
My Dad sold our 58 Chevy with a 348 V8 and bought a 1960 Biscayne with the straight 6 and powerglide just before I got my driver's license. Hmmm...
[ATTACH]
Harbor Freight... JK- I don't know.
That's the best idea, most adhesives and epoxies soften/melt at 400-500°F. Use a torch, slowly play it around the top, use an infrared thermometer...
Year I graduated from high school.
The correct tool may not open the ring far enough to remove it. I've had that experience more than once. This setup is adjustable depending on...
I have a fax interface set up on my computer hooked to the landline. Unknown or obviously spoofed numbers get a fax tone. Or sometimes an answer...
I have a Creality Ender 3 V2, have had good luck with it. 3D printing parts is Ok, I've made quite a few. Two caveats, parts aren't as strong as...
As others have suggested, if you really do have low pressure measured with a gauge while spinning the oil pump with a drill, pull the pan, look...
Any of you old farts on here still have something like this stuck on your beer fridge?[ATTACH]
A couple of useful pages (a few ads will pop up) The Top 10 Free 3D Modeling Software for Beginners in 2022 | All3DP The Best 3D Printer Filament...
For most automotive wiring that's exposed to any kind of weather, I've started using the crimp connectors that include heat shrink and a sealer...
And frustrating sometimes. ;)
Separate names with a comma.