Grieve NB-350 industrial powdercoat oven. 100-450 degrees, 115 volt single phase. 27x24x18 inside measurements. 41x28.5x23 outer measurements....
Here's a lecture on pre-hospital road race accident treatment from Dr. John Hinds. He was part of (I'm assuming a huge part of) a rapid response...
I'm curious what you guys sent each other...sounds fun!
Thanks guys. I'll shoot stickboy a message and see what he recommends for me. I guess it would be kinda dumb to go through setting the bike up,...
Mpusch-nope never done any track days. I suppose I should look into getting some race tires, and tire warmers, and a generator. I feel really...
I go to Central KY for parts too. Good guys and they do very good on prices. I'll probably just run my Pilot Power 2CTs until i figure out if i...
Thanks! I'm an aircraft mechanic by trade, so I think I'll be fine with mine. It's a treat when I get to work on my own stuff. What class/classes...
Sounds fun to me!
Hope that's not sarcasm! Haha, don't know a lot about the track. Just what I've seen on Youtube.
Nice! I'll shoot you a message. We may even end up racing each other (clubman novice?) Seems like a popular category for sumos and R3's alike....
Thanks! Looks like Talledaga 4/22-23 is my best bet so far.
Thanks guys. Looks like I might just try clubman novice at the first track that's close enough with a race school. I'll have my eyes peeled for...
Decided with a gentle nudge from a friend to come race with you guys. I've never raced and would like to do the WERA race school to get my...
Separate names with a comma.