What are some good ss tweaks lol I know nothing about ss
They say no on crank specifically then below say no again. I'm assuming it's no all around lol http://www.pathvalley.com/600cc-Micro-Rules.html
I asked them today via email while asking for turn around time on hf pump. Completely ignored the question. Answered turn around time that's all
In the sprint car world I see and hear of lots of people speaking of internal mods they do to improve oil flow in some areas that the r6 is...
I know Adams. Thank you. I had a highly recommended builder do one for me. Lasted about 30 min. Now i do my own. Lol im more involved than most...
Yea thats what im thinking. If i could get another point or even half point of cr with pistons i wouldn't even be asking. But i dont see any...
Im mainly looking for real world experience or if im lucky dyno experience. Will i gain anything by going aftermarket? Even a hp or 2. Seems like...
Im going to rebuild my motor this winter. I have 1 slightly damaged piston. I am trying to decide if i should go with a stock or a set of Je or...
I have taken a washer that is the OD that I've needed, and some cut off each side leaving a flat on each side. Make it small enough that it will...
That was the original hg. I put a .50mm in it. I just looked back and checked I have .026 in squish. Yes it has stock pistons.
I fat fingered the keyboard. I meant .035in but I did find .038 at the largest. That was with the original hg i put the head back on to measure...
Thank you very much sir. I got it down to 107.5 with .055in on tightest with lash set to .007-.009
Ok thank you! So you think I should dial back the exhaust timing a bit. Maybe try and get under 120? As long as I can maintain .055in ptv
Separate names with a comma.