Bought a 2018 that's was crashed. I can not get it started but cranks really good. So I checked all fuses and all are good, pump primes, did notice that the TB do not cycle when bike is powered. Swapped out the TB but still do not cycle or started, swapped ECU, pump relay and tip over and no help. Opened airbox and sprayed done gas in TB and bike started but was starving for fuel and revved to about 10k when it first came on then wouldn't pass 4k. Would idle for at about 1600 or so and then shut off. Don't have another pump to try but since it primes I figured its good. I didn't check the pressure. Any help is appreciated. Darwin
Was the crash on the right side? Had a similar issue - ended up being a faulty kill/starter switch! This was with a 08-16 r6. Sent from my iPhone using Tapatalk
So I ended getting an OBD cable and used a reader and got the following code. P0030 - O2 Sensor (02 Sensor has been removed so it should be there) P0476 - EXUP (EXUP has been removed so it should be there) P048d - EXUP (EXUP has been removed so it should be there) C1555 - I can not find this code anywhere in the manual. Anyone know what this is?
Solved. Pump was bad. It primed during the start and also when disconnected it shot a 4 foot stream but it was bad.