Pitbull TRS

Couple of questions about the TRS. I'm getting one complete unit from the PO of my SV650. Can I use it with the wheel chocks (a good brand) I already have mounted in my enclosed trailer?
I'm looking to mount another TRS for my 2009 Triumph Street Triple. There is a used one for sale that says 'WIDE' would this fit the street triple with the correct pins or is it too 'WIDE'? Thanks, Rich

 

OK, i finally found my answer to the WIDE question, it's a no go for my Street Triple.

 

No need for it. If you're worried about the front wheel moving doing transport I use a bungee to slow/minimize it.

Plus, sometimes the latches can't fall if you are too far off from pulling straight in. Just turning the wheel left/right will pivot the backend and allow it to fall in place. Can't do that with a wheel chock.

 

If you're looking for pins for your street triple, @RRP might be interested in selling you a set.

 

Thank you both.

 

The Pit Bull Wide bar fits the normal TRS trailer mounts. I use both in my trailer.

 

OK but wouldn't the distance to mount the pins into the axle be to wide?

 

Yeah, you can't use a wide BRACKET on a bike that wants a normal BRACKET, as the axle mounts would be too wide.

Both the wide and normal BRACKET use the same trailer floor PLATE though.

Ah, and I just re-read your posts and realize I had your question backwards. You were looking at buying a used wide bracket to use on a bike that needs a normal one, yeah, no go, and my bad.

 

No worries, thanks for confirming!