2023 zx6r fully race/track prepped FS

Location: NC, original owner and title in hand.

Asking Price: $15,000;

Hello fellow enthusiasts, for sale is my 2023 zx6r that I purchased brand new. This motorcycle has been meticulously take care of by myself and PITLANE MOTO with all of the upgrades you could wish for. First 500 miles were ridden on the street and the last ~1,000 have all been track miles= currently ONLY 1,453. No major incidents, only cosmetic damage seen in pics are from low mph, deep corner run offs in to wet grass unfortunately. The body work has some rash on the sides and a small crack or 2 in the front but nothing major which is why I continued to ride and have not replaced them (sure wish we had gravel traps in the U.S.). Only reason to seek is to go another route…… aka I get bored. The bike is fully safety wire prepped for advanced TDs/Wera/ASRA. Please feel free to reach out for any questions or inquiries.

Upgrades include:
0 Lightech aluminum brake lever guard
0 Lightech swingarm spools
0 Driven aluminum rear sprocket 44 & 43 tooth
0 DID ERV7 Series 520 Race chain
0 EBC Roace Race front brake pads
0 Graves Carbon full exhaust
0 Driven Captive wheel spacers
0 Lightech chain adjusters
0 BMC air filter
0 Driven 90 degree valve stems
0 Graves smog block off plates
0 Spiegler Front and rear brake lines
0 Brembo 19mm RCS corsa radial brake master cylinder
0 Brembo brake reservoir mounting kit
0 woodcraft side stand elimation plug
0 woodcraft rear sets/ GP shift
0 Graves keyless gas cap
0 woodcraft key switch elimination harness
0 Lightech oil filter cap
0 Driven superbike grips
0 Armour Race bodywork
0 WRS Windscreen
0 Vortex 7 degree clip ons
0 OHLINS FGK 227 - NIX 40 inserts (currently sprung for ~180 lb rider)
0 OHLINS TTX GP shock
0 Translogic quickshifter
0 R & G Tank sliders
0 Yoyodyne Clutch (buttery smooth - only been used on 1 track day so far)
0 GPR V5 stabilizer
0 Motion Pro REV3 throttle kit (road race cam installed)
0 GB Racing engine cover set
0 Woodcraft LH/RH. race handlebars switches (on/off/star =keyless)
0 Carbon Fiber exhaust hanger
0 Front Caliper speed bleeders
0 Evotech radiator guard

Care
0 Always serviced with MOTUL 300V 10w40
0 Always serviced with MOTUL RBF700 Factory Line Racing Brake Fluid
0 STV/Exhaust servo eliminate
0 Tuned/DYNO by PITLANE MOTO
0 Suspension work done by PITLANE MOTO

Please DM me with email address and I will send pictures, unfortunately I have an issue posting in this thread, thank you!

 

If you size them to below 1MB each, then you can post in this thread.

 

See attached photos

 

Additional photos

 

GLWS. What triple is that?

 

Thanks boss, Stock triple clamp.

 

Is it milled down or anything? I was under the impression this was the stock triple:

 

I digress, you are correct. I just cant recall what I got when I got the woodcraft ignition delete. I’m going to need to do some searching now because I am curious.

 

I cannot for the life of me identify which one, but this is an aftermarket Top Clamp to obviously allow the clip ons.

I do know I did not install an entire new triple clamp though.

 

Yeah i figured it was just the top part of the clamp. It looks sick and I like how flat it is. I've had my zx6r a long time and never seen that clamp before so I wanted to inquire =) Would love to know if you figure it out!

 

Bump to keep it alive!

10k of aftermarket parts my people!

 

Bump

 

Bump asking $14,500

 

Same, my 2024 would look incredible with the clamp and TFT in place

 

The triple clamp is a package deal with the GPR mounted stabilizer. It is machined to fit and mount the stabilizer. https://www.gprstabilizer.com/find-kit/?type=street-bikes&make=kawasaki&model=zx6r&years=2019-2025