Clean oil doesn't absorb moisture. (It isn't DOT4 brake fluid.) Clean oil doesn't go bad in an opened bottle or your engine. Combustion...
So far I have found: Engine RPM Gear Position Clutch Switch Throttle Position Rate of change of Throttle position Secondary Throttle Plate...
Now that people are awake I and start the engine. I can already see my gain for the RWS -> MPH conversion is off a little. [MEDIA] Rob
So I’ve found and identified a lot of data in the raw CAN stream, still more to ID though. I’ve managed to create a small CAN driver/protocol to...
When you bought these nearly 0 miles calipers, why was the other person selling? Was it because his brakes were rubbish? Well if all you need to...
I think suspension travel is likely a very good data point to have. Rate of change will tell you if you have insufficient damping too, for rebound...
Yes possibly. But I was spinning both wheels by hand, with the bike on the stands. I can spin the front a lot quicker as it doesn’t have the added...
Small update. I am working on the assumption the wheel speed sensor readings are in pulses per second, this seems ”logical”. I have started to...
So CAN ID 010, byte 3 & 4 is rear wheel speed, I believe. I had ignition on, engine off, bike on paddock stands and I spun the rear wheel by hand...
Hi, first time poster (I think?) Okay, my aim (pun not intended, read on) is to reverse engineer the can-bus on my Gen4 (2012) ZX-10R, standard...
Separate names with a comma.