An acquaintance of mine is trying to rebuild a 02 CBR954. He needs a full gauge cluster. Let me know if you have one laying around that you may...
Sorry for the long post and question from my bbs legal experts... My good friend (over 30 years old) was in a serious accident and is currently in...
Just as the title states... I am looking for a good 00-p1 R1 engine. Mine R1 had a left side tip over before I bought it and has a hairline crack...
I just scored a used 86 Nighthawk S for cheap... it is the blue/white with red stripe one. I am looking for a right side cover panel and the...
5 sets of front softs and soft rears motoamerica spec tire 180/55/ZR17 rear and 120/70/ZR17 front KR451 Rear soft 0129 KR448 Front Soft 0129 Born...
Buddy is selling his 2021 Race bike. 2021 Kawasaki ZX-6R 636 KRT Edition Race Bike (660 miles) Comes with the following upgrades and Parts 1...
If you have your own tire changer... what is your setup? Who has a "mobile" setup that they can take to the track?
Just for discussion purposes... I see on the CCS Facebook page there is some drama about ccs dropping the ball on sending in paperwork for racers...
Buddy of mine is looking into dipping his toe in the MotoAmerica Supersport round(s). What transponders do they use? Would my old school 260 unit...
As the title states... Buddy of mine is looking to buy a set of Kawasaki 636 wheels (2013 - 2021 should all work). Better if all the rotors are...
So my question is... Is Kawasaki coming out with a Ninja 700 for 2022???
Found a 87 Yamaha FZR750RT that has a FZR1000 engine, early 90's Ninja 750 front end, and late 80's Ninja 750 rear end on it. Located in Nevada....
Anyone know what became of Fallicon company that did crankshaft etc? Buddy of mine from the UK is looking to construct a Yamaha YZF750ish racer...
Guys... I picked up a 74 TM250 and need a few parts to get her fired up. I need the left side engine case cover and a kick start lever. I figure...
Buddy of mine from the UK ordered a Wiseco piston kit from Suncoast a while ago. Now apparently Suncoast has dropped the ball and my buddy hasn't...
Anyone on here have access to make a top mount steering damper bracket for me? I already have the layout and dimensions on a drawing. It is going...
I started a thread in the Texh section... so if you have any input to put it there. Buy I am looking for info on converting my 2001 R1 to a total...
I have a 2001 R1 I only use for track use. Would like to swap to a total loss electric system. Anyone know of a "kit" to use.
I was just watching a short review of the Livewire on Motortrend TV. They were showing the bike from the rear... the rear signals are vertical and...
My brother is rebuilding a 96 Kawasaki ZX6 600 Ninja. He is looking for a clean nose fairing, side panels, fairing/mirror bracket, turn signals,...
Separate names with a comma.