Another question for you guys. On the IOM do you set up the bike so it bottoms at e.g Bray Hill as a compromie to have better grip elsewhere?...
Have another question to you Shaun Do you set the bike up so it doesnt bottoms? Or do you compromie and let it bottom out at e.g bottom of Bray...
Thanks for a good reply! It got me thinkin a bit. And from what you said I think this is my Manx suspension story. As we had to much sag...
Old Ohlins cartridge from 08/09 (With rebound/compression in both legs) Weigh 70 kg without gear and is 180 cm high / 155 lbs - 5 stone 11 inches...
Hello Had my first go at the Mountain circuit last year in the Manx Grand Prix. Had the best 2 weeks of my life and planning to go back this...
Looks like i have to continue with that. To get one of theese to Norway i will have to pay approx 50 dollar shipping, 25% Norwegian tax on the...
Hello Just wondering if any know of a good Carbon Fibre fairing stay for a 09 R6? Want a one pice with the airduct and a big innlet. The...
Have you tried some adhesive aluminium looking tape? Used it under the tank on my R6, and when i come in after a session on the track, the tank...
Have investigate a little. And for me it looks like the R6 06-11 has a speed sensor on the tranny output. So why would they then need a gear...
Sweet. Tough do you know where to connect it on a Yec harness?
Do you know if the R6 also has a gear position sensor? Could not find it on the wire diagram.
Was thinkin the same. Everyone who have tried them over the old Pirelli slicks brags about the new ones. Hope its the same with the Supercorsas =)
Just wondering if anyone have tried the new profile 180 Pirelli Supercorsa's? (180-60-17) Any info to share? =)
Thanks m8!
THats the only way i can see it be done. Tough i dont know how to!?
Hello Just wondering how do you adjust the shiftlight on a R6 2009 with yec ecu? The software doesnt do it I am sure off.
Suomy! Awesome helmets. Nothing bad to say except they are expensive. Crashed 3 shark helmets last year. Could be a coincident but i have had...
Thanks for good reply guys. Tough i tought the pistons, cam chain tensioner, and the cams where upgraded? But if there is no significant hp...
Hello I am building a supersport engine. I have the stock engine in my 08 R6, and a almost brand new 06 engine wich is only run in. It would...
As i have the YEC harness i only needed the pressure gauge. Bought it from a guy in sweden. Tough I would se if I could find a shop closer to you....
Separate names with a comma.
