I have a old but almost new set of Chicken Hawk warmers. They were my 4th set so I only used them a couple times. I purchased them a long time ago...
I haven't made bodywork in a long time and needed a set for the 200... turned out pretty good. It's all made using vacuum infusion, the fabric is...
I have a couple 08+ R6 airboxes but I'm not sure what year they are. Any way to get that information from the numbers stamped on them. Most of the...
Are the 06/07 and 08+ throttle body injectors the same? I have a few sets and one is from a 07. To order new ones they are the same part number...
SIDI Meg-1 air used one trackday session so some scuff marks on the shifter area. Size 44 $300 shipped. Email [email protected]
Plugging the laptop into the bike the YEC ECU comes up as a unknown device. Reloading the software hasn't helped, 3 different laptops, good...
I picked this bike up 2 years ago to set up for racing but life got in the way of that. It had a minor low side on the left when I bought it. 2011...
I haven't been doing many projects lately but I did make some Triumph tank sliders that turned out pretty good. Knapp tested one at the NJMP...
Sportbike Leather Service did some great work for me at a very fair price. I had a hole in the hip, trim hanging off, and Dan found some top...
As Jim would say "you guys have to record everything" :D I combined my crash video with Cale Jones and Oliver Goodens video from Grattan. Cale did...
Building a 2011 ex250 for ess next year... Should I cut the kick stand bracket off the frame, or does it have enough ground clearance? I would...
The season was over for me after PIRC and I'm already bored. So I made some silly bling for the race bike :) I think I'll do the huger as well....
Who's in? I can't wait.
Manda (NC WERA Official) placed 1st in class and 1st overall female in her first power lifting competition :) [IMG]
What is a 86 FXZ700 worth? 56xx miles, org paint (black/red) , couple small chips on the tank and a 1.5" scratch on the tail. New tires (5...
:) [IMG]
I make my own bodywork and have played with composites for some time and I'm impressed with the Armour Bodies Signature series. I'm doing some...
Unfortunately Seth Van Dongen tested a tank cover/slider I made (he is fine). It worked about how I wanted it to :) The slider part is .060"...
I need the widest point of the belly pan on the 1996-2010 Honda RS125. I have 18" in my notes but it doesn't seem right. Thanks.
Finished the wife's pit bike tail. Turned out ok, red is a bit darker then I was going for. Making the other parts in a few weeks. [IMG] [IMG]
Separate names with a comma.