Oklahoma. Tulsa. I'm open to shipping PM me your email or phone
Whoops! $8000 even! and ill offer open communication for the buyer to help get it setup or any questions.
2012 Suzuki GSXR 750 CMRA Race Bike CMRA prepped for Superstock but runs Formula 1, Superbike B Superbike A, Superstock A and Superstock B AK20...
Knot just yet. But I wish he would leave(s)
Thanks guys, ill take everything under consideration. my family owns and operates a auto repair shop for the last 40+years and I am a mech...
and did i post im reusing a head gasket??? im only had planned on reusing the case covers..clutch and stator.
Melk. thanks for the info, ill start looking into your points. as far as 3 hours, thats only to measure the bearing to my measurements and supply...
thank you Tom. ve speced out and being supplied by the local shop. I was concerned with valve springs as ive seen thats a common issue floating...
Metric: thank you for the thoroughly thought out response. And yes I agree, the top end will be gone through but it isnt my primary focus as the...
Why are you even in this thread about engine rebuilds racer880 when you cant even cut an exhaust down(which fyi changes the flow...
im the one being cheap when this racer880 guy is trying to buy ebay rotors...good luck with that, hope that isnt why you run into me...
it means get the fuck off my thread if you have nothing to contribute ya stuck up troll. Post up your WERA Number, ill come say hi
uber a pro wrench? i feel like we got off on the wrong side here...you guys anti work on your own bike people? and no one is trying to take...
Metric. What exactly was the advice? Ia it not intelligent to ask why or do you guys jump off a cliff if someone tells you to
Just to clarify. When I rebuilt my Ducati, I could have calculated the preload pressure on the crankshaft when the cases are put together however...
Yes to validate any knowledgebase values against my own. And again so what? do you use an "expert" dealership when you need oil change or any...
why Is it unknown when I can measure the clearances to spec to see if the wheel and cover have any slop? There isnt much science behind an oil...
All we have is a valve cover off as of right now which we don't see any damage from the top side but we have yet to look at the back side to see...
Hey guys, this isnt my first rodeo, but will be my first yamaha engine rebuild. SO I NEED YOU EXPERTISE TO REVIEW THE GAMEPLAN and Thread!(THANKS...
lol whoops! i did say i wrecked pretty hard! this time im alittle further though....i was able to get a trackday on it after the cleaning of it
Separate names with a comma.
