2008 Yamaha R6 Superbike (146HP) Full Ohllins $15,999

​

2008 Yamaha Superbike R6 Full Ohlins Endurance Set-Up $15,999 ​

Have Clean FL Title in hand

List of Items On the R6

• Livengood Superbike +2mm Blueprinted Motor Build and Mapped (146HP)! Have receipt
• YEC ECU and Harness
• 2 Maps U4 & MR12
• Ohlins 25mm Front Suspension Kit
• Rear TTX Ohlins
• Ohlins Steering Dampner
• All Suspension Serviced by Thermosman Suspensions (Mike Fitzgerald)
• Translogic Auto Blip Assist No Clutch Downshift
• Nemesis Traction Control
• Translogic QuickShift GP Shift
• Electronic Auto Rev Warm-Up
• Anti-Gravity Lithium Battery
• Zullo Racing Push Button On-Bar Traction Controls
• Zullo Racing on Bar Start/Stop Buttons
• Custom Fab Triple Clamp Key Delete On/Off Toggle
• U4 / MR12 Switch on Bar
• Quick Fill Gas System On Tank (Fast Gas)
• Fuel Tank Traction Pads
• Full Yoshimura Titanium Alpha T Exhaust
• Fast Frank Full Quick Change Front
• Fast Frank Full Quick Change Rear
• Brembo 19X18 Master Cylinder
• Brembo 320mm Front Floating Rotors
• A.I.M. Lap Timer Triple Clamp Mount
• WoodCraft Frame Sliders
• Sharkskinz Full Body Work (Tail, Upper, Lower)
• GP Tech Race Seat Pad
• Full Vortex Rear Set with GP Shift
  
• Vortex Clip Ons with Vortex Bars
• Quick Turn Throttle
• Brake Guard
• Clutch Guard
• WoodCraft Stator Case Cover with Slider
• MotoD Metal Oil Cap
• Battery Tender Quick Connect
• Zero Gravity Wind Screen

Spares List

1 x SharkSkinz Full Set (Upper, Lower, Tail) Upper was professionally repaired/ Lower, Tail Used
1 x Dyno Jet Quickshifter Push 4-102
1 x Vortex Rear Set Right RS616DR
1 x Vortex Rear Set Left RS616AR
2 x Vortex Foot-Peg Left RSP04AK
2 x Vortex Foot-Peg Right RSP04BK
2 x Vortex Folding Shifter Toe Peg RSP01K
1 x Nylon Slider
1 x WoodCraft Foot-Peg 06-4300
1 x Woodcraft Shifter Toe Peg
6 X Vortex Bar with Sliders CLR001K
1 x Vortex Bar with slider Used
1 x Vortex Clip-Ons Set Used
1 x Stock Shifter Assembly
1 x Fast by Frank Rear Axle Nylon Slider R602
1 x ZeroGravity WindScreen 24-580-01
3 x ProBolt WindScreen Silver Bolt Kit SK8S
4 x Black Windscreen Bolt Kit
1 x Zero Gravity 8 WindScreen Bolt Kit 32-140
2 x Yamaha Head Bearings 93399-99951-00
1 x All Balls Racing Head Bearing Kit 0410-0101
1 x Yamaha Crankcase Cover Gasket 2C0-15461-01
1 x Yamaha Shifter Boot Cover 4XV-18154-00
7 x Yamaha Rear Wheel Sprocket Spacers 90201-10021
7 x Yamaha Rear Sprocket Locking Nuts 90185-1009
2 x Yamaha Oil Gasket Crush Washer 214-11198-01
5 x Yamaha Injector O-Ring 5PS-14147-00
4 x Yamaha Injector O-Ring 90430-09002
1 x Yamaha Fuel Pump Tank O-Ring 19B-24486-01
1 x Yamaha Stator Gasket 2C0-15451-01
1 x Yamaha Bolt Stud 90116-10485
4 x Yamaha Oil Filter 5GH-13440-70
4 x Yamaha Clutch Plates 168-16324-00
4 X Motul 300V 5w-30 Liter
1 x Fuel Pump Tank Mounting Bracket Used
1 x Shift Rods misc Adjustments
1 x Yamaha Stock Seat Used
1 x Fuel Tank with Vortex Fuel Cap
2 x Rear Sprocket Carriers Used
8 x Rear Sprockets Vortex-42,42,44, New 41 Renthal-45,43,43, New 44
1 x Renthal Front Sprocket 16 Used
1 x PBI Pro Front Sprocket 16 Used
1 x Motion Pro Throttle & Cable Used
4 x Brake Pad Sets Vesrah XX Super RJL XX VD-248XX
1 x Tech Spec Tank Grip Set 62-0075-33
1 x Tech Spec Tank Grip Set 62-0075-33 missing left diamond side
2 x Stomper Grip Tank Side
2 x Bike Master Clutch Lever 5EB-83912-01-00
1 x Clutch Lever Used
2 x Clutch Housing Levers Used
1 x Top Triple Clamp Used
1 x Renthal Grips Medium Compound G148
1 x Fast Gas Quick Fill Tank 5gl with Stand 1500
1 x Yamaha Swing Arm Used
1 x WoodCraft Stator Case Cover 60-0449LB-B
1 x WoodCraft Stator Skid Pad 65-0440A
1 x Pit Bull Rear Stand
1 x DP LightTech Front Stand
1 x Yamaha Front Wheel with Braking Wave Rotors KBA 6110
1 x Yamaha Front Wheel without Rotors
2 x Yamaha Rear Wheels with Rotor
1 x Set Custom Pit Bull Axle Pegs for Carrier Trailer Restraint System (Fits Quick Change Axle)​

 

• The only thing on the bike that is 2008 is the Frame and the Cases.
• Yes! It has traction control and throttle blip clutch-less downshifts, Yes it works seamlessly.
• All motor work was performed from Livengood Motorsports / +2mm Blueprinted Superbike Build Over $7,500 (documented)
• All electronics (Traction control, Quick Shifter, Auto-Blip, Engine Braking) by (Larry) Zullo Racing of Moto Corse Performance
• Changed Oil and Oil Filter EVERY Track-day or Race weekend.
• Quick Change Front Rear & Fuel (the easiest tire changes you will ever have)
• 146 RWHP if you don’t believe me I will dyno it before you buy

I hate to admit this but I am too old (48) and cannot use this bike to its potential. I would like to see my R6 go to someone who can use it to Win races. This is one of the best motos I have ever raced. It has been the fastest of its class in every event I have raced and it is the most reliable, best handing moto I have ever experienced. I have been racing and winning for a long time, I have experience to tell you this bike is amazing and with no issues. Asking $15,999 It is located in Fort Lauderdale, Florida



Here are some people on this forum you may know who can vouch for me and this R6:

Gino Angella Gino230
Mark Tenn https://www.marktennmotorsports.com/
Stefano Mesa (@stefano37)
Bob Fisher https://roaringtoyz.com/
Carl https://www.motocorseperformance.com/
GRod GarrettRick​

If you are looking for a turn key full race setup I would entertain selling my Custom Trailer (insulated), Pit Scooter (Zuma), Generator, Tools, Warmers, Tents, Fans...... everything in the race trailer. You could hookup and pull to the track and need nothing.

Please feel free to PM me for my Cell # I will be happy to answer any questions you have.
-Jason Edmonds










Note the tabs






I have a new slider and cover as a spare if you cant stand the scratch.

 

The discoloration is a bubble under the paint were the MR12 got under.
The tank is in perfect condition not repaired. Only cosmetic (paint).

 

Set Custom Pit Bull Axle Pegs for Carrier Trailer Restraint System (Fits Quick Change Axle)






16tooth / 15tooth is currently on the bike.

 

Can you send more pics?

I have ridden this bike, it's FAST and handles like a dream!

 

Great bike, great ad. GLWS

 

Would you consider selling the Nemesis TC system?

 

Holy pictures, that's how all pictures of bikes should be taken, just smaller images haha.

Good luck with sale!

 

Its hilarious watching all the dip shits on FB arguing over the hp numbers.

 

Is this on the TDJ for page?

 

I think so. Id have to look again. That or TDJU.

 

Yes, Owner doesn't have Social Media so I shared the crap out of it.

 

Had dinner with the owner last night, he's willing to entertain "reasonable" offers....

 

I have a couple questions..thanks in advance!

1. What year is the engine?
2. Are you using all the same 2008 wiring harness?

 

Hey Omar! I will ask him, I think it's the same harness from '08, but it's the YEC harness / ECU. Also, the engine cases are '08 as far as I know. When Livengood did the refresh, I know that any part that was the least bit questionable was replaced new- clutch basket was the example he gave me.

Gino

 

those are big numbers for a 600, wonder about longevity?

 

Yes they are big numbers, but not impossible on a 2mm overbore and full superbike build. The folks on FB are screaming about how its impossible, when most of them have never even been on track.