1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Triumph 675 Slipper clutch which one to buy?

Discussion in 'Tech' started by donovangravlee, May 4, 2009.

  1. donovangravlee

    donovangravlee Active Member

    Im looking for a slipper clutch for my Daytona.

    Do any of you have one in your Daytona?
    If so which brand should I go with?
     
    donovangravlee, May 4, 2009
    #1
  2. Yoyo

    Yoyo Well-Known Member

    Yoyodyne!
     
    Yoyo, May 4, 2009
    #2
  3. mille52

    mille52 Old, Slow and Not Crabby


    Absolutely!!!!!
     
    mille52, May 4, 2009
    #3
  4. donovangravlee

    donovangravlee Active Member

    Is installing a slipper clutch about the same difficulty as installing a new chain+front and rear sprocket?
     
    donovangravlee, May 4, 2009
    #4
  5. Yoyo

    Yoyo Well-Known Member

    The worst part of the job is getting the big nut off of (and back on) the trans input shaft.
    Other than that, it is pretty simple stuff.
     
    Yoyo, May 4, 2009
    #5
  6. donovangravlee

    donovangravlee Active Member

    hmmm. is that the nut that holds the front sprocket on?
     
    donovangravlee, May 4, 2009
    #6
  7. Yoyo

    Yoyo Well-Known Member

    The Front Sprocket is on the Trans OUTPUT shaft.
    The slipper clutch is on the INPUT side of the trans.
     
    Yoyo, May 4, 2009
    #7
  8. donovangravlee

    donovangravlee Active Member

    ah I see.
    Do I need to buy anything else with the slipper or is this a complete kit?
     
    donovangravlee, May 5, 2009
    #8
  9. Yoyo

    Yoyo Well-Known Member

    We suggest new plates and a new clutch cover gasket.
    No "special" tools are required.
     
    Yoyo, May 5, 2009
    #9

Share This Page