I'm installing my new translogic setup on a 09 r6, And i'd like to avoid wiring it to the brake lever and have it powered by 12v all the time. Any input on the best way to go about it?
Also the thing I just ran into, when connecting to the coils, the quick shifter connects to all 4 of course, I have that figured out, the issue is when I ran the auto bliper to the coil, it connects to one of the coils also. But there's no way to connect both the bliper and the quickshifter to the coil. Am I missing something?
Just to follow up on my install - I ran the signal wire from the CABS unit to an SPST on/off switch at the handlebar. I didn’t have to use the grey ground wire because the Bazzaz QS unit is wired 12V/signal/ground - so adding a second ground unnecessary. My clutch switch is not involved in the system. Sent from my iPhone using Tapatalk