All of these came as spares with my bike and I have no need for them. As far as I can tell there is no damage to any of them. - rotors measured at 4.6mm thick and seem to be flat (Asking $200) - tank fits a 2009-2012 model as far as I know (could be wrong, I'm not too knowledgeable on RSV4's (Asking $250) - not sure which year the swing arm fits, I assume 2009-2014 at least? Maybe someone else that knows this stuff better than chime in (Asking $250) Shipping cost will vary based on location. Located in Hampton Roads, VA area. If interested, please PM me, because then I get an email and will see it right away. I don't check this forum daily so if you just reply here it may be a while until I see it.
That's a pre aprc tank. So won't fit any with aprc since it doesn't have the mounting point for the IMU sensor. Sent from my iPhone using Tapatalk
So 2009-2012 was correct then, but won't fit the Factory models, just the R right? Any input on the swing arm? Do you know if those changed throughout the different generations?
Won't fit a 12. I believe 11 Factory had aprc and the R did not. Basically 09-10 tank. There was your tank. Then 11-12 was one. Then 13-16 was the same. Those had an extra void underneath for the abs. Then then 17+ the IMU is repositioned again and the mount doesn't work with the older tanks. Sent from my iPhone using Tapatalk
Damn, that's a lot of changes to something that looks the same at first glance lol You're right about 2012, but I'm seeing a couple of them on ebay that came off 2011 model and they look the same as mine. Maybe I should've just said "first gen RSV4 tank" and call it good. Can't edit the post anymore though unfortunately :/
From the side the non aprc tanks have a more rounded shape. Then the part the seat covers. That's where the difference really are after that. Sent from my iPhone using Tapatalk