1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

DID ERV3 master link pin size after install

Discussion in 'Tech' started by borislav, Jul 5, 2011.

  1. borislav

    borislav Well-Known Member

    Like title say I would like to know what should be diametar of the head on installed master link pin on DID ERV3 chain.

    Thanks in advance
     
    borislav, Jul 5, 2011
    #1
  2. afm199

    afm199 Well-Known Member

    4 or 5 thou more than the unriveted width.
     
    afm199, Jul 5, 2011
    #2
  3. borislav

    borislav Well-Known Member

    Thanks for the info!
     
    borislav, Jul 5, 2011
    #3
  4. GoldStarRon

    GoldStarRon Well-Known Member

    I am not sure if this is related to your question, but be aware that DID went to a "dual size" master link on some of the newer chains... if you happen to have a master link for an older DID chain it will be loose fitting to the link (like a worn out spot). This is not good for sprocket wear, or..??

    Ron
     
    GoldStarRon, Jul 6, 2011
    #4

Share This Page