I was peeling up an old 3M clear film and it was coming up fine. When I got to the front I noticed it had taken some of the clear with it over the pin striping. I'll probably take it to a local body shop. Can they clean this up or am I looking at a total respray?
3000? id start with 400-600 and make sure the bond is good on delam edge with a metal pick(delicate lift of edge)....good way to know if it will happen again btw feathering requires good wet sanding skills(u cant see when its wet)
Luckily the clear on the stripe is higher than the clear on the red and white so I didnt need to feather it too much, just softened the edges. It came out ok, but I sanded thru on 3 small spots.