1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

2009 YAMAHA R6 track bike for sale.

Discussion in 'Bikes for Sale' started by Nicky69, Mar 25, 2022.

  1. Nicky69

    Nicky69 Well-Known Member

    If anyone is looking for a great track bike, I'm parting with my previous ride.
    2009 Yamaha R6 Track bike, No title – Bill of sale only $7200.00 price is firm.

    Phil Rider (937) 243-5874

    Motor probably has a total of 5000-6000 miles on it. Not the original engine. I replaced it with a low mileage 2009 several years ago.

    New Parts:
    Crankshaft
    Rod and Crankshaft bearings
    Rod bolts
    Head Gasket
    Cam Chain and Guide
    Slotted Cam Sprockets (cams degreed to supersport spec)
    Oil Pickup tube
    Transmission Bearings both Main Shafts
    Clutch Plates Springs
    Battery
    Radiator
    Manual cam chain tensioner

    Engine has approximately 2 days 20220325_003318.jpg 20220325_003259.jpg on it after the rebuild

    Aftermarket Parts:
    K&N Air Filter
    Speigler braided steel brake lines
    Woodcraft Frame Sliders
    Woodcraft Case Covers
    Woodcraft Clip-ons
    Woodcraft Keyless Start Wiring
    Woodcraft Chain shark guard
    Driven rear wheel adjusters w/Sliders
    ETI – Fuel Cell Gas tank covers (Crash protection)
    Keyless billet aluminum race gas cap
    Silicone Coolant hoses with Samco clamps
    Motion pro over flow bottle
    Arrow Full Exhaust System. Stainless Steel Header w/ Ti- canister
    Ohlins 30mm Cartridges Front Forks Serviced 2020 (6 track days on them)
    520 Chain and Sprockets ( 3 extra master links)
    Vortex Rearsets
    Progressive throttle tube for smoother throttle maintenance
    Full Bazzaz Fuel management System (Quick Shifter, Ignition, Traction Control, Self Mapping function) Note: Has a remote connection point on the upper triple tree to connect to the Bazzaz
    ECU wired for Flash Tune Hookup
    ECU has been flashed to improve performance. Limits removed
    Dzus Fastener for Seat removal
    Woodcraft Bodywork (Good to fair condition) w/ Dzus fasteners
    Quick disconnect upper fairing front fasteners
    Zero Gravity Double bubble wind screen
    Right Angle tire valve stems
    Rental grips
    Zeta Levers (Clutch and Brake)
    Brembo Front master cylinder 18X19
    Vesrah RJL8 Front brake pads

    Service Items performed recently:
    Engine teardown and rebuild
    Carbon build up removed from valves and piston tops
    Valves clean and adjusted to spec
    Bike has been gone completely through
    Oil and filter change 10w-40 Maxima Synthetic
    Brake fluid changed
    Liquid Performance (non-glycol based coolant
     

    Attached Files:

  2. CooperG3

    CooperG3 Member

    where is the bike located? Will you ship bike?
     
  3. Nicky69

    Nicky69 Well-Known Member

    Bike is located near Columbus ohio. Hadn't thought about shipping the bike. Where would you need it shipped if need be?
     
  4. Robby Ringnalda

    Robby Ringnalda Well-Known Member

    How are you in columbus and i dont know you?
     
  5. Nicky69

    Nicky69 Well-Known Member

    Actually in Marysville. Up at Mid Ohio most every track day.
     
    Newtothegame likes this.
  6. Tim Dobbertin

    Tim Dobbertin Well-Known Member

    This answer's Robby's question. :D
     
  7. Nicky69

    Nicky69 Well-Known Member

    *** SALE PENDING ***
     
  8. Nicky69

    Nicky69 Well-Known Member

    **** SOLD ****
    Guy came today to pick it up. Thanks for all the interest
     
    michaelrc51 likes this.

Share This Page