I was always taught, if it worked before you touched it and it doesn't now it's usually something you did.
Jimmy Chance, Quality Machine Quality Machine
Check your pm's please
I think I have a rebuilt motor taking up space in the corner of the shop.
:bow:
Can someone point me to an article/article written by the likes of Road Racing World, Cycle World, or any other nationally published magazine in...
Shoot me your address I'll shoot you one.
Yes!
DO you ever look on the floor when you're in there. If not do so next time that will give you some type of indication.
I've seen that with some of Leslie tools.
I have a cornwell tool guy but I don't have a lot of tools from them. the only thing I've gotten from them were specialty tools. temp gun a few...
6mm Allen?
What year do you need? I have a set of R-6 Rods hanging on the wall, can't remember the year but I'm sure Rick or Ed could tell which ones they...
Look into getting a Impact Screw Driver, and a small propane torch to heat said torx sockets up before attempting removal
Stop by any of your franchise dealerships, they should have all four stopping by, some may not have Mac or Cornwell, typically I see them not...
I have all three, Race tool box is mostly Craftsman, I have exactly what I need to rebuild a bike at the track, engine too. Shop, I have a mix of...
It is possible to use another lower trans carriage on a 1000. But I would let someone who has experience building motors perform the task. Have...
I need a .018 Head Gasket for a 2004-2006 Yzf R-1. Need Asap, if anyone has one please Contact me at 301-516-4144.
06-07 fuel pump points to the right i think, and the 08-09 is the opposite can be fixed by swapping fuel pump bases. From what I can tell there...
Yes it's possible. PIA aligning the ex sprocket on the intake cam but i have a set of busa sprockets I use to help align them since it's a common...
Separate names with a comma.